Security Link SL150 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 89)

Section 16 -Zone Programming

16–7

will not be deleted if the zone is temporarily disabled by

answering “No” to the previous prompt.

If only the physical transmitter is to be removed or changed

(that is; its serial number deleted, as when replacing a unit that

has a nonremovable battery), it can be done in

✱

56 Zone

Programming Mode, as indicated next.

To Delete a Transmitter Serial Number

The abbreviated procedure below can be used to delete a transmitter serial number from a

zone, using the

✱

56 Mode (5800 system).

1. In the Programming mode, press

✱

56 to enter Zone Programming mode.

2. Then enter the zone number, and press [

✱

] repeatedly until the cursor is under the RF

Input Loop (L) position. This is the specific input (loop) or button on the transmitter that

has been entered for that zone.

Enter 0 in the loop number field.

The serial number will change to all 0's. Note that the other programmed values for that

zone will not be deleted. This will allow you to reinstate a new transmitter in its place.

10 INPUT S/N:

A000-0000 0

If 0 was entered in error, simply re-enter the loop number, and the serial number will

return to the display.

Press [

✱

] to accept.

A display for the next zone number will appear. To exit, enter 00.

Press

✱

99 to exit the Programming mode.

To Enter and Duplicate Wireless Keys

If the D key was previously pressed on page 16-4 to enter and duplicate 5804 and/or 5804BD

wireless keys, the following screens will appear:

TEMPLATE ?

1–6 1

Enter Template number 1–6 (from next page).

1–3 = 5804 templates; 4–6 = 5804BD templates. See the

defaults provided for each template in the chart that follows

these procedures.

2. Select from templates. Press [

✱

] to display template (1 shown

selected). Note: If necessary, press [#] to back up and re-enter

template number.

3. Press [#] if you want to return to zone attributes screen.

L 01 02 03 04

T 21 22 23 28

When [

✱

] is pressed, the selected template will be displayed.

Top line of display represents loop numbers, bottom line

represents zone type assigned for each zone.

5. Press [

✱

] to accept template.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 143 144

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Link SL150 Anleitung zur Fehlerbehebung Seite 89

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Security Link SL150