Security Link SL150 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 62)

SL150 Installation and Setup Guide

13–2

Entering Program Mode

You may use one of the following methods:

a) Press [

✱

] and [#] keys at the same time within 50 seconds after power is applied to the

control; or

b) After power-up, enter 4 1 1 2 (Installer code) + 8 0 0.

This method is disabled if you exit the Program mode using

✱

98 instead of

✱

99. See the

paragraph titled, Exiting the Program Mode, later in this section.

If a different Installer code is subsequently programmed, use it instead of 4112 to gain

access to the Programming mode.

When you enter the Program mode, data field

✱

20 will be displayed (this is the first data field

in the system). The system will now accept entries for field

✱

20.

Programming a Data Field

1. Press [

✱

] + [Field No.] (for example,

✱

22), then make the required entry.

2. When you have completely programmed a data field, the keypad will beep three times and

then automatically display the next data field in sequence. To go to a different field, press

[

✱

] plus the desired field number.

3. If the number of digits that you need to enter in a data field is less than the maximum

digits available (for example, the phone number field), enter the desired data, then press

[

✱

] and the next data field number to be programmed.

4. If you try to enter a non-existent field, the keypad will display EE or ENTRY ERROR.

Simply re-enter [

✱

] plus a valid field number.

Reviewing a Data Field/Erasing an Entry

Press [#] + [Field No.]. Data will be displayed for that field number. No changes will be

accepted in this mode.

To delete an entry in a field, press [

✱

] + [Field No.] + [

✱

] (applies only to fields

✱

το

✱

44,

✱85, ✱86, ✱87, ✱

88, and

✱

94).

Interactive Mode Programming (

✱

56,

✱

58,

✱

80,

✱

81,

✱

82)

Typical prompt displayed

during Interactive mode

programming:

Enter Zn Num.

(00 = Quit) 01

Press [

✱

]

[Interactive Mode No.]

(for example,

✱

56). The

alpha keypad will display the first of a series of prompts

requesting entries.

A detailed procedure (with displays of prompts) is provided in

later sections of this manual.

Zone Number

Interactive Mode Used to Program

✱

56 Zone Programming

Zone characteristics, report codes,

alpha descriptors and serial numbers

✱

Expert Mode

5800 Series Transmitter serial and

loop numbers

✱

80 Relay Programming

4229 or 4204 Relay modules, or

Powerline Carrier devices

✱

81 Zone List

Programming

Zone lists for relay/powerline carrier,

assignment of chime zones, and Pager

1 and 2 reporting zones

✱

82 Alpha Programming

Zone alpha descriptors

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 143 144

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Link SL150 Anleitung zur Fehlerbehebung Seite 62

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Security Link SL150