Security Link SL150 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 15)

Section 2 - Installing the Control

2–3

Swing the base of the board into the mounting clips and secure it to the cabinet with the

accompanying screws (see Detail B).

Insert the top of the control's board into the slot in the clips and position two long (red)

clips at the lower edge of the board (see Detail C).

Swing this board into place and secure it with two additional screws.

Insert grounding lugs (supplied with the receiver) through the top of the cabinet into the

left-hand terminals of the antenna blocks (at the upper edge of the receiver board). Secure

the grounding lugs to the cabinet top with the screws provided, as shown in Detail D.

Insert the receiver's antennas through the top of the cabinet, into the blocks' right-hand

terminals, and tighten the screws.

10.

Refer to

Section 6: Wireless Expansion (5800 System)

for receiver setup and wiring

instructions.

LONG

MOUNTING

CLIPS

CABINET

DETAIL D

ANTENNA AND GROUNDING LUG INSTALLATION

ANTENNA

MOUNT

(2 PLACES)

ANTENNA

(2)

SCREW

(2)

SHORT

MOUNTING

CLIPS

CONTROL

CIRCUIT

BOARD

SUPPORTING

SLOTS

HOLES FOR ANTENNAS

AND GROUNDING LUGS

RECEIVER CIRCUIT BOARD

(See Detail D)

RCVR BRD

DETAIL A

SIDE VIEW

OF BOARD --

SUPPORTING SLOTS

CIRCUIT

BOARD

CABINET

DETAIL B

SIDE VIEW OF

SHORT

MOUNTING CLIPS

DETAIL C

SIDE VIEW

OF LONG

MOUNTING CLIPS

GROUNDING

LUG

(2)

Figure 3. Mounting the PC Board and RF Receiver Together in the Cabinet

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 143 144

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Link SL150 Anleitung zur Fehlerbehebung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Security Link SL150