Security Link SL150 Betriebsanweisung PDF herunterladen (Seite 56)

- 56 -

Appendix –

Macro Key Programming & Usage

About the Macro Key (C key)

The “C” key can be used to automatically activate a series of commands of up to

16 keystrokes. These keystrokes, as a group, are called macros and are stored

in the system's memory.

You (or your installer) can program the “C” key to be used for these commands

(check with your installer if necessary).

Typical macro functions can include:

•

Arming sequences: STAY, INSTANT, AWAY, or MAXIMUM

•

Bypassing particular zones

•

Activating relay(s) for turning on (or off) lights, fans, etc.

What to Include in a Macro Program

Over time, you may find that you frequently enter the same series of commands

into your keypad. For example, you may bypass the two upstairs window zones,

then turn on an exterior light, and then arm the security system in the AWAY

mode. Rather than entering the numerous keystrokes this would normally

require each time, you can program the “C” key to perform the entire sequence

by simply pressing the “C” key and then entering your 4-digit user code at the

prompt that immediately follows – a total of only five keystrokes.

If the “C” key has been set to function as a Macro key*, you can program this

key with any desired series of commands. Using this feature, up to 16

keystrokes can be programmed. The Macro can be initiated only when the

system is disarmed..

Refer to the

Security Codes

section. To enable the “C” key to function as a macro

key, follow the procedure under “To Add or Change a Usere’s Code”.

How to Program a Macro Key

To program macro functions for the “C” key, first do the following:

Enter your

4-digit security code

press the

[

]

key,

then press/hold the

Macro

[

] key for at

least two seconds. This prompt appears

Enter “1” or “2”. Remember, there are two macros available, but only one

macro can be assigned to a user.

LRN WHICH MACRO?

0, 1 or 2

1 2 ... 51 52 53 54 55 56 57 58 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Link SL150 Betriebsanweisung Seite 56

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Security Link SL150